General Drill Cycle Information

Double-click on the ‘General Drill Cycle Information’ node under the ‘Automatic Canned Cycles’ node. Next, select the ‘General’ tab.

Copy all the settings shown in the graphic below.

Make sure to review what is displayed when you allow the cursor to hover over a specific input field or control as well as what is in the information area at the bottom of the interface as you move through the various input fields and controls.

Next, select the ‘Positioning’ tab. Copy all the settings shown in the graphic below.

Make sure to review what is displayed when you allow the cursor to hover over a specific input field or control as well as what is in the information area at the bottom of the interface as you move through the various input fields and controls.

Next, select the ‘Cycle Parameters’ tab. Copy all the settings shown in the graphic below.

Make sure to review what is displayed when you allow the cursor to hover over a specific input field or control as well as what is in the information area at the bottom of the interface as you move through the various input fields and controls.

Next, select the ‘Dwell Information’ tab. Copy all the settings shown in the graphic below. Make sure to review what is displayed when you allow the cursor to hover over a specific input field or control as well as what is in the information area at the bottom of the interface as you move through the various input fields and controls.

Next, select the ‘Feed Information’ tab. There are no special cycle feerate registers or tap cycle feedrate registers required.